Mazda Recalls, Technical Service Bulletins TSB's, Diagnostic & Repair Tips
If you encounter a customer complaint of a squeaking or creaking noise from right rear suspension while driving over bumps, be aware that updated rear coil spring parts are available through the MNAO-Technical Hotline. Repair Procedure: 1. Replace both rear coil springs (even if noise comes from only right rear side) with updated (improved) parts according to the instructions … Read more
2013-16 CX-5, 2014-16 MAZDA3 AND MAZDA6 – CREAKING NOISE FROM FRONT LOWER ARM BUSHING Some customers may notice a creaking noise from the lower arm when driving over road bumps at 20-40 km/h. This is caused by stick-slip of the front lower arm bushing. The noise occurs when the road surface is wet or … Read more
IGNITION SHUT OFF DURING MAZDA CONNECT UPDATE MAY RESULT IN DAMAGE TO THE CMU DO NOT shut off the ignition or let it shut off at any time during the MAZDA CONNECT update process, otherwise the CMU may be damaged and need to be replaced. IMPORTANT: If the ignition is left in the ACC … Read more
2017 Mazda6 Turn Signal Switch Does Not Cancel Some customers may complain about a turn signal switch that does not cancel. This concern may have occurred after an accessory fog light installation by the port. Repair Procedure Note: This service alert does not apply to 2017 Mazda6 vehicles with Grand Touring trim. Note: Do not … Read more
2016 CX-9 – Exterior Side Garnish Damage Due To Improper Vehicle Lift When lifting a CX-9 vehicle, adjust the height of the vehicle lift extension pad to prevent lift arm contact with the exterior side garnish. If not adjusted properly, the exterior side garnish and/or a fender may be damaged by the vehicle lift arm. … Read more