| “This site contains affiliate links for which OEMDTC may be compensated” |
2008-2010 TRIBUTE – IGNITION KEY BINDING IN IGNITION CYLINDER WHEN TURNING TO START POSITION ONLY
APPLICABLE MODEL(S)/VINS
2008-2010 Tribute built on or before 08/03/2009
Ignition key that is binding in the ignition cylinder when attempting to turn to the Start position only.
This may be due to a damaged steering column lock module.
REPAIR PROCEDURE
- Verify steering column lock module is the source of concern.
- While on level ground, position the steering wheel in the straight ahead position and remove ignition key.
- Turn the steering wheel clockwise and counterclockwise to verify the steering column lock restricts rotation. The steering lock should engage before +/- 15 degrees of rotation, and will be a hard metal stop in each direction.
- Does the steering column lock engage in each direction?
- Yes – Do not continue with this procedure. Refer to MS3 online or Workshop Manual (section 09-01F).
- No – Proceed to step 2.
- Replace the steering column lock module per MS3 online or Workshop Manual (section 06-12).
NOTE: When replacing the steering column lock module, the ignition lock may be difficult to install due to the lock’s retention pin not seating properly. If encountered, remove and discard black ring on the back of the lock cylinder.
PART(S) INFORMATION
| Part Number | Description | Qty. |
| ZZDB-66-160 | Lock Module | 1 |
I have a 2008 mazda tribute and there was a recall on the ignition switch and I am having problems with mine now. What do I need to do and where can I take it to to be fixed
Go to you dealer, and see if they will fix it.