“This site contains affiliate links for which OEMDTC may be compensated” |
2007-2015 CX-9 – RATTLE AND/OR WIND NOISE FROM FRONT DOOR GLASS AREA
APPLICABLE MODEL(S)/VINS
2007-2015 CX-9
Rattle noise and/or wind noise from the front door glass area while driving the vehicle.
This is caused by a deformed glass run channel (A).
The deformed area is located at the upper rear corner of the run channel and is caused by repeated door glass closures in very hot climates.
The deformed area causes poor contact between the glass run channel and the door sash, which results in rattle noise and/or wind noise.
REPAIR PROCEDURE
- Open the rubber sheet set and identify the Type A piece and the Type B piece according to the shapes shown below.
NOTE: One Type A piece and one Type B piece repairs one (1) door.
- First, apply the Type A piece to the upper rear corner of the new run channel (as shown below), then apply the Type B piece.
NOTE:
- Apply the rubber pieces to the new run channel BEFORE installing the new run channel onto the vehicle.
- Use a locally procured rubber adhesive.
- Remove the old glass run channel from the vehicle.
- Install the new glass run channel onto the vehicle after the rubber adhesive has fully dried.
- Repeat steps 1 – 4 on opposite side door as necessary.
PART(S) INFORMATION
Part Number | Description | Qty. | Notes |
TKY2-58-607 | Rubber Sheet Set | 1 or 2 | Set includes one Type A piece and one Type B piece. One set repairs one door. |
TD11-58-605D | Channel, Glass | 1 | Right |
TD11-59-605D | Channel, Glass | 1 | Left |
Price Disclaimer